I’ve heard this comparison so many times I ran some experiments. A number 8 1.5" coated decking screw inserted into two one by pine boards through the grain by a hammer holds about half as well as one inserted using a screwdriver. One hit to drive the screw is better than several, but a two hit approach (one to set the angle of the screw tip, the second to send it home) was most reliable. Drilling a pilot hole before hammering improves things pretty significantly, up towards 3/4 of the holding power of a driver driven screw.

On the other hand, even very slight misalignment between the hammer swing and the screw can result in failure, and the board was always more damaged by a hammer inserted screw.

I ran out of crtcs, but I wanted another monitor. I widened a virtual display, and drew the left portion of it on one monitor, like regular. Then I had a crown job that would copy chunks of it into the frame buffer of a USB to DVI-d adapter. It could do 5 fps redrawing the whole screen, but I chose things to put there where it wouldn’t matter too much. The only painful thing was arranging the windows on that monitor, with the mouse updating very infrequently, and routinely being drawn 2 or more places in the frame buffer.

Modern operating systems have made it take very little knowledge to connect to WiFi and browse the internet. If you want to use your computer for more than that, it can still take a longer learning process. I download 3D models for printing, and wanted an image for each model so I could find things more easily. In Linux, I can make such images with only about a hundred characters in the terminal. In Windows, I would either need to learn powershell, or make an image from each file by hand.

The way I understand “learning Linux” these days is reimagining what a computer can do for you to include the rich powers of open source software, so that when you have a problem that computers are very good at, you recognize that there’s an obvious solution on Linux that Windows doesn’t have.